Pilot

This product interests you?

You wish to place an order, receive more information about our products, thank you

Technical spécification

Height:	With monitor 1025mm / 40” With cowling 726mm / 29” – without 670mm / 26”
Width :	With flux bottles 1090mm / 43” – without 915mm / 36” with solder bath out 1380mm / 54”
Depth :	700mm / 28” to 963mm / 38” with keypad tray out
Board size :	330mm x 250mm / 13″ x 10″
Edge clearance :	Above / below 3mm
Height clearance :	Above / below 40mm nominal, 55mm Max
Solder :	All commonly used solder types – including lead-free
Solder pot capacity :	6kg / 13lb
Applicators :	– AP style – 2.5mm to 16mm Ø. – Extended AP style – 2.55mm to 20mm Ø – NB – Micro nozzle – 1.5mm to 2.5mm Ø – Jet-Tip style – 6mm to 40mm Ø. – Special dedicated nozzles available upon request
Flux :	Low maintenance Drop-Jet system. Low solids (below 8%), no clean flux, pressurised and inerted system, optional water-soluble system available
X, Y & Z Axis resolution :	0,1mm
Repeatability :	+/- 0,05mm
Nitrogen usage :	30 liters gas/min.
Pression :	5 bar
Nitrogen purity :	99,99% Ou supérieur
Power supplies :	Single phase + PE – 208V / 250V – 50/60Hz
Power :	4kVA including bottom-side IR preheat
Transport :	Hand load
Tooling :	Integral adjustable board guides, includesfinger extensions and board clamps
Programming :	Fonctionne sous Windows : – PillarCOMM ‘Point & Click’ –

• Integral PC and machine mounted TFT monitor

• Inerted nitrogen system

• Drop-Jet fluxer

• Two AP style solder nozzle tips

• Internal fume extraction

• Colour programming camera

• Two universally adjustable tooling carrier

• PillarCOMM LITE

• Windows® based ‘Point & Click’ interface

• Lead-free compatible

• Day-to-day service kit

• Fume filtration system

• Manual fiducial correction

• Micro nozzle assembly

• PillarPAD offline programming system

• Multiple level password protection

• Bottom-side preheater

• PillarGEN 30 nitrogen generator and machine stand