Pilot

Technical spécification

  

Height:

With monitor 1025mm / 40”

With cowling 726mm / 29” - without 670mm / 26”

Width : 

With flux bottles 1090mm / 43” - without 915mm / 36”

with solder bath out 1380mm / 54” 

Depth : 700mm / 28” to 963mm / 38” with keypad tray out
Board size : 330mm x 250mm / 13" x 10"
Edge clearance : Above / below 3mm
Height clearance : Above / below 40mm nominal, 55mm Max
Solder : All commonly used solder types - including lead-free
Solder pot capacity : 6kg / 13lb
Applicators :

- AP style - 2.5mm to 16mm Ø.

- Extended AP style - 2.55mm to 20mm Ø - NB

- Micro nozzle - 1.5mm to 2.5mm Ø

- Jet-Tip style - 6mm to 40mm Ø.

- Special dedicated nozzles available upon request

Flux :

Low maintenance Drop-Jet system. Low solids

(below 8%), no clean flux, pressurised and inerted

system, optional water-soluble system available

X, Y & Z Axis resolution : 0,1mm
Repeatability : +/- 0,05mm
Nitrogen usage : 30 liters gas/min.
Pression :  5 bar 
Nitrogen purity : 99,99% Ou supérieur
Power supplies : Single phase + PE - 208V / 250V - 50/60Hz
Power : 4kVA including bottom-side IR preheat
Transport : Hand load
Tooling : Integral adjustable board guides, includesfinger extensions and board clamps
Programming : Fonctionne sous Windows : - PillarCOMM ‘Point & Click’ -

 

 

Standard features

• Integral PC and machine mounted TFT monitor

• Inerted nitrogen system

• Drop-Jet fluxer

• Two AP style solder nozzle tips

• Internal fume extraction

• Colour programming camera

• Two universally adjustable tooling carrier

• PillarCOMM LITE

• Windows® based ‘Point & Click’ interface

• Lead-free compatible

• Day-to-day service kit

 

 

System options

• Fume filtration system

• Manual fiducial correction

• Micro nozzle assembly

• PillarPAD offline programming system

• Multiple level password protection

• Bottom-side preheater

• PillarGEN 30 nitrogen generator and machine stand

This product interests you?

You wish to place an order, receive more information about our products, thank you

Fill in the contact form